Troubleshooting Guide - Frigelux Rdp300Be Manuel D'utilisation

Place the freezer door on the center hinge, making sure the
7
hinge pin is inserted into the hole at the bottom of the freezer
door. Place the top hinge on the freezer door, securing the
screw and cover.
8 Remove the top hinge from the freezer door, rotate the top
hinge 180 degrees, remove the hinge pin, reverse it and
reinstall it on the opposite side .
Take the left top hinge cover parts from the bag and install
9
them on the left side, tighten all the screws.

7. TROUBLESHOOTING GUIDE

You can solve many common refrigerator problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling for service.
Problèmes
Unusual noises
The fridge does not
get cold enough
Your appliance
does not get cold
at all
Frost forms inside
your appliance
The door is difficult
to open
✓ Check the adjustment of the feet of your appliance and its stability.
✓ Check that it is not touching a wall.
✓ Check that all the movable parts (trays, racks, etc..) are securely in
place.
✓ Check if the temperature is correct. If this is not the case, adjust the
temperature appropriately.
✓ Make sure that you have not placed a large amount of food or hot food
in your appliance.
✓ Be careful not to open the door too often or leave it open.
✓ Check that the door is closed tightly.
✓ Keep your device away from heat sources.
✓ Make sure that the ventilation around the unit is respected.
✓ Check that your appliance is connected to the electrical supply.
✓ Check that the circuit-breaker for your house has not cut out and that
the fuse has not blown or been unscrewed
✓ Be careful not to open your appliance's door too often and not to leave
it open.
✓ It is normal for the door to offer some resistance to being opened,
particularly when you have just shut it: a slight under pressure forms in
your appliance to ensure the door seals perfectly. AIl you have to do is
wait a few seconds before re-opening.
32
Solutions