Publicité
Note: Make sure the rubber gaskets seal properly with the appliance all around the doors
before tightening the hinge screws the model with handles).
14. Remove the left hole plugs, screw off the bolts, and remove the right hole plugs.
15. Install the right hole plugs on the left side of the door and install the handle on the right
side of the door.
Note: Make sure the rubber gaskets seal properly with the appliance all around the door before
tightening the hinge screws.
Replacing the lighting lamp
This device is made up of light-emitting diodes (LEDs). This type of
diode cannot be changed by the consumer. The lifespan of these
LEDs is normally sufficient for no changes to be made. However,
if, despite all the care taken during the manufacture of your device,
the LEDs are defective, please contact your after-sales service for
any intervention.
7. TROUBLESHOOTING GUIDE
You can solve some common problems on your own and easily, thus saving the cost of a repair
call. Try the following suggestions to see if your problem can be solved without help from a
troubleshooter.
Problems
Power cut
Unusual noises
The device does not
cool enough
Solutions
During a power outage, frozen food will be preserved for
approximately 8h
Do not open the freezer too often during a power outage.
✓ Check the adjustment of the feet of your device and its stability.
✓ Check that it is not in contact with a wall.
✓ Check that all removable parts (bins, shelves, drawers, flaps,
etc.) are in place.
✓ Check if the temperature is set correctly. If not, adjust the
temperature appropriately.
✓ Check that you have not put a large quantity of food or hot food
in your appliance.
✓ Be careful not to open the door of your appliance too often or
leave it open.
✓ Check that the door is tightly closed.
Publicité
