Auto Focus; Focus Control; Iris Control - Security-Center EcoLine TV7090 Instructions D'installation

Stop the auto pan function
To stop the auto pan function simply press the button
The LED is not lid.
NOTE: As long as the auto pan function is activated (LED is lid) it is not possible to control the
speed dome manually or choose a different function. Stop the auto pan funtion first.

AUTO FOCUS

AUTO FOCUS
The
focusd when in range. The speed dome camera always focusses on the center of the picture. Objects which
are not in the center may not be focussed and displayed sharp (especially at a high zoom ratio and a narrow
viewing angle). If you want to adjust the focus manually or to programm a preset position the auto focus
function needs to be deactivated by pressing the

FOCUS CONTROL

FOCUS CONTROL
The
the picture.
NOTE: In cases where also the manual focus does not increase the sharpness of the picture zoom
out and widen the viewing angle. Try to focus again. If you have chosen a very narrow viewing
angle and a high zoom ratio the focus area is only about 0,5m to 1,5m.

IRIS CONTROL

IRIS CONTROL
The
NOTE: The function IRIS CONTROL is only available for the following modes: „auto exposure", „auto iris"
and „manual".
NOTE: The smaller the iris opening, the bigger the focus area. It may happen that under day light
conditions (bright light, small iris opening) the whole picture is displayed sharp. During night time
use or under low light conditions (big iris opening) parts of the choosen picture (especially in front
of and behind the focus point) may not be displayed sharp.
CHANNEL SELECTION
CH+/CH-
The button enables the user to select the next higher (+) or lower (-) speed dome ID number.
button activated the auto focus function of the lens. Objects will be automatically
is a button that enables the user to manually set the focus and sharpness of
is a button that enables the user to manually set the iris control.
AUTO PAN
again.
AUTO FOCUS
button. (LED is not lid).
16