Operation - Security-Center EcoLine TV7090 Instructions D'installation

Operation

System reset and first usage
After connecting all necessary cables startup the system linking by following this proceedure. The same
proceedure is nedded to reset the system:
1.Step: Press the button
The LCD displays the following message:
The LED starts flashing.
2. Step: Press the button
The system linking will start, search the system connection device and make sure that all the
connected devices are probably linked.
When the display shows the following message
error has been occurred. In this case refer to step 3, else the camera is ready for the setup.
3. Step: Check the cabeling of the communication cable from the keyboard to the connected speed dome
cameras. After the power up proceedure of the speed dome, it check the pan and tilt functionality.
Having checked and sorted the circuit and the speed domes power condition, press the
SYS RESET
button
Manual control of the speed dome
1. Step: First choose the camera that you want to control. Therefore key in the ID of the speed dome as a
three digit number, e.g.
2. Step: Confirm your ID number by pressing the
The keyboard's LCD displays:
3. Step: Use the joystick to manually control the spees dome (up, down, left, right, speed)
NOTE: To be able to set up the speed dome's postition precisely also at a high zoom ratio, press the
SPEED BY ZOOM
the speed dome's speed according to the zoom ratio. The higher the ratio, the slower the dome will move.
The function only works for manual control, not when changing preset positions.
4. Step: Use the buttons
ZOOM TELE
The button
viewing becomes more and more narrow.
ZOOM WIDE
The button
viewing becomes wider.
SYS RESET .
SYS RESET
again.
again.
0 0 1
for the speed dome with the ID 1.
⎡
DEVICE
⎢
⎣
button. The function is activated if the button's LED is lid. The function slows down
ZOOM TELE
and
is used to zoom in. Objects are displayed bigger. The angle of
is used to zoom out. Objects are displayed smaller. The angle of
⎡
SYSTEM LINKING?
⎢
⎣
⎡
DEVICE
⎢
PRESS SYS
⎣
ENTER .
button
⎤
001 _ :
⎥
⎦
ZOOM WIDE
, to set the zoom ratio accordingly.
13
⎤
⎥
⎦
⎤
: XXX LOST
it means that an
⎥
RESET
⎦