Testing And Checking - SCS Sentinel INTENSIVE 3A Manuel D'installation Et D'utilisation

● F3 function settings:
Logic F3-1
Gate Status
Closed
Open
Stop during moving
Closing
Opening
Logic F3-2
Gate Status
Closed
Open
Stop during moving
Closing
Opening
Logic F3-3
Gate Status
Closed
Open
Stop during moving
Closing
Opening
The position of safety devices:
●
Safety Edge
Photocell
E

3.5 TESTING AND CHECKING

Make sure the notices included in 1.1 General safety precaution "WARNINGS" has been carefully observed.
● Release the gearmotor with the proper release key.
● Make sure the gate can be moved manually during opening and closing phases with a force of max.
390N (40 kg approx.)
● Lock the gearmotor.
● Using the Key selector switch, push button device or the radio transmitter, test the opening, closing and
stopping of the gate and make sure that the gate is in the intended direction.
● Check the devices one by one (photocells, flashing light, key selector, etc.) and confirm the control unit
recognizes each device.
9
The reactions of the photocells when detecting obstacles
Photocell 2 Photocell 1
Stop opening
No effect
Stop opening
No effect
Closes the leaf
The reactions of the safety edge/ photocell when detecting obstacles
Safety Edge
Stop opening
Stop opening/ closing
Reverses to open for 2 seconds
Reverses to close for 2 seconds
The reactions of the loop detector/ photocell when detecting obstacles
Loop Detector
Open
Open
Open
Open
No effect
Reloads automatic closing time
Reloads automatic closing time
Open Locks and, on release, reverses to open
No effect Locks and, on release, continues opening
Reloads automatic closing time
Reloads automatic closing time
Loop Detector
Photocell 1
Photocell 2
Photocell 1/ Photocell 2
Stop opening
Photocell 1
No effect
Reloads automatic closing time
Open
No effect
Photocell 1
No effect
Reloads automatic closing time
Open
No effect
Photocell 1
or
Photocell 1 / Photocell 2