Becker Centronic TimeControl TC4410-II Notice De Montage Et D'utilisation page 49

SETTING
INTERMEDIATE POSITION, VENTILATION/TILT, Prog END POSITION
(time/position programming)
First select the desired channel in Operating mode using the
channel selection button.
INTERMEDIATE
POSITION
1. You have confirmed the HOLIDAY function. INTERMEDIATE POSITION
appears.
2. You can set the INTERMEDIATE POSITION running time using the +/-
button. The running time is given in seconds or you move to the INTER-
MEDIATE POSITION from the upper limit position using the UP/DOWN
button.
3. Confirm with OK. VENTILATION/TILT appears.
4. You can set the VENTILATION/TILT running time using the +/- button.
The running time is given in seconds or you move to VENTILATION/TILT
from the lower limit position using the UP/DOWN button.
5. You have confirmed the VENTILATION/TILT menu item. PROG END POSI-
TION appears.
6. You can choose between PROG END POSITION, PROG INTERM POS and
PROG VENT/TILT using the +/- button.
Your selection determines which position the shading solu-
tion moves to from the upper limit position at the set switch-
ing time. Ventilation/tilt is only started once the relevant run-
ning time has elapsed.
7. Confirm your selection with OK.
8. The PROG END POSITION function is now set.
9. For details on further programming in the SETTING menu, please con-
tinue reading.
VENTILATION
PROG
END POSITION
49 - en