Yamaha TT-R125S Manuel D'atelier Du Proprietaire page 162

switch coupler, engine stop

switch coupler, clutch switch

coupler and start switch cou-

pler, put a connector cover on

the couplers and push them in

at the rubber cover end.

◊ Pass the wire harness on the

outside of the main switch cou-

„ Do not allow the primary coil

lead to slacken where it is bare

of the protecting tube.

All manuals and user guides at all-guides.com

CABLE ROUTING DIAGRAM

Ù Fasten the CDI unit lead and

starting circuit cut-off relay lead

with a plastic locking tie at the

tape holding the main switch

lead, engine stop switch lead,

clutch switch lead, and start

switch lead together.

Á Position the starter cable, throt-

tle cable, CDI magneto lead,

wire harness and rear shock

hose (TT-R125LWE only) as

Û Fasten the wire harness, throttle

cable, starter cable, CDI mag-

neto lead and rear shock

hose (TT-R125LWE only) at the

protecting tube for the CDI mag-

Fasten the rectifier/regulator

lead as shown.

Do not allow the CDI magneto

lead to slacken.

Position the plastic locking tie

ends as shown.

Chapitres