Yakima ROC 4 Mode D'emploi page 2

PUSH BASE ONTO
CARRIER MAST.
Insert second bolt with a
washer into adjacent hole.
Position clear sleeve so
bolt can pass through.
Attach washer and nut.
ATTACH CARRIER
TO TRAILER HITCH.
Insert carrier into hitch.
The hole in the hitch
must align to the
hole in the carrier.
1032414B-2/15
ALIGN HOLES IN MAST AND BASE.
At center hole near end: Insert bolt and washer.
Attach another washer and nut to bolt.
TIGHTEN with adjustable-end
wrenches or 9/16" wrenches.
WARNING:
DO NOT OVER-TIGHTEN
THIS BOLT!
If you have
purchased the
QuickHitch,
install it here
and continue at
step 11.
Insert pin into
holes in
plates and
through mast.
INSERT hitch bolt and
washer from RIGHT TO LEFT.
TIGHTEN bolt.
TIGHTEN with
adjustable-end wrenches
or 9/16" wrenches.
Secure wire onto
end of hitch pin.
SECURE hitch bolt
with safety clip.