Technical Data; Cleaning And Maintenance - M-E VISTUS VD-6310 Mode D'emploi

VISTUS-VD | ENGLISH
Brightness (7" monitor)
Press the button (C.8) on the indoor station once and the OSD will
display 'Bright'. You can now increase the brightness using button (C.9)
and reduce it using button (C.10).
Contrast (7" monitor)
Press the button (C.8) on the indoor station twice and the OSD will
display 'Contrast'. You can now increase the contrast using button (C.9)
and reduce it using button (C.10).
Colour saturation (7" monitor)
Press the button (C.8) on the indoor station three times and the
OSD will display 'Colour'. You can now increase the colour saturation
using button (C.9) and reduce it using button (C.10).
Melody selection (3.5" and 7" monitor)
The next melody is played every time you press the
The last melody to be played is automatically stored.
OPERATION (as door intercom system)
1. Press the bell button.
2. The stored ring tone will play on the corresponding indoor station(s)
and the screen will show the image of the outdoor station.
3. Accept the conversation on the indoor unit by pressing briefly on the
talk button ( ).
4. If an external camera is connected to the outdoor station then you
can switch to it by briefly pressing the 'monitor' ( ) button. Press
on the button again to switch back to the internal camera.
5. If a door opener is connection then you can activate it by briefly
pressing the door opener button ( ). The bell button will light
green for the duration of the door opener as confirmation.
6. Press the talk button ( ) briefly in order to switch the system back
to standby operation.
Note: If a floor button is connected then an unchangeable ring tone
is played when the floor button is activated. This ring tone is fixed
and is not included in the 'normal' tones/melodies to make it easy to
differentiate.
OPERATION (as internal house intercom)
All indoor units that are connected to the same bell button can also be
used as an internal intercom.
1. Press the internal button
2. To accept the conversation on one of the other connected indoor
3. The talk button needs to be pressed briefly on one of the two
Note: It is not possible to set different ring tones for internal and
external calls.

Technical data:

Outdoor station
Operating voltage:
Standby power:
button (B/C.11).
Camera resolution:
Camera capture angle:
Connection for door opener: ~ 12V DC, max. 0.9 A
Indoor station (3.5")
Operating voltage:
Standby power:
Monitor resolution:
Bell button illumination:
Indoor station (7")
Operating voltage:
Standby power:
Monitor resolution:
NOTES
The functionality of the unit can be affected by the influence of strong
static, electrical or high frequency fields (discharging, mobile phones,
radios, microwaves).

Cleaning and maintenance

Always disconnect mains powered units from the mains supply before
cleaning (disconnect the plug). The unit housing can be cleaned using
a soapy soft cloth. Do not use any abrasive materials or chemicals.
Remove dust build-up from ventilation slits using a brush and clean up
using a vacuum cleaner. Do not hold the vacuum cleaner nozzle directly
against the unit.
18
(B/C.7) on the indoor station from
which you wish to reach another indoor station. All the connected
indoor station will ring. No image will be shown.
stations you need to briefly press the talk button there (B/C.6).
indoor stations in order to end the conversation.
15V DC
<0.5W
380 TV lines
Horizontal 125°; vertical 90°
15V DC
<0.5W
320x240px
automatic via CDS sensor
15V DC
<0.5W
480x270px