VEVOR RCH-6050 Mode D'emploi page 7

5. The hydraulic cylinder that has been put on hold for a long time due to the
hardening of the seal has not worked for a long time, thus affecting the service life
of the hydraulic cylinder, so the hydraulic cylinder should be pumped 2-3 times a
month when it is not in use.
6. Hydraulic cylinder factory after 105 Mpa (1050 kgf/cm²) experiment.But
because the seal easily ages, the user usually needs to check; in general, it is six
months; for frequent users, it's three months. Try to press with the 87.5 Mpa
(875kgf/cm²) while checking; if you have already blown up, convex rise, seep into
to wait for a phenomenon, then it can not be used.
7. Should strictly obey a technical specification while operating; the customer
wanted a check according to using a circumstance periodically with maintenance.
Manufacturer: Shanghaimuxinmuyeyouxiangongsi
Address: Shuangchenglu 803nong11hao1602A-1609shi, baoshanqu, shanghai
200000 CN.
Imported to AUS: SIHAO PTY LTD. 1 ROKEVA STREETEASTWOOD NSW 2122
Australia
Imported to USA: Sanven Technology Ltd.
Rancho Cucamonga, CA 91730
UK REP
EC
REP
YH CONSULTING LIMITED.
C/O YH Consulting Limited Office 147, Centurion
House, London Road, Staines-upon-Thames,
Surrey, TW18 4AX
E-CrossStu GmbH
Mainzer Landstr.69,
60329 Frankfurt am Main.
Suite 250, 9166 Anaheim Place,
6