Emglo K15A-8P Guide D'utilisation page 23

CODE POSSIBLE CAUSE
27 Extremely light duty cycles
28 Piston rings damaged or worn
29 Cylinder or piston damaged or worn
30
Compressor cylinder finish worn
31 Water in pump oil
32 Manual lock unloader lever in open position
33 Regulator open
34 Possible defective motor or starting capacitor
35 Paint spray on internal motor parts
POSSIBLE SOLUTION
Run unit for longer duty cycles. It is recommended that a
50%-75% average duty cycle be maintained; that is, the air
compressor pump should not run more than 30-45 minutes
in any given hour.
Contact an EMGLO factory service center or an EMGLO
authorized service center.
Contact an EMGLO factory service center or an EMGLO
authorized service center.
Contact an EMGLO factory service center or an EMGLO
authorized service center.
Drain oil and refill pump with EMGLO Synthetic Blue
compressor oil.
Rotate manual lock unloader lever to the closed perpendicular
position.
Rotate the regulator knob counterclockwise to its built-in stop
and push knob in to lock in place.
Contact an EMGLO factory service center or an EMGLO
authorized service center.
Contact an EMGLO factory service center or an EMGLO
authorized service center. Do not operate the compressor in
the paint spray area. See flammable vapor warning.
23