Emglo K15A-8P Guide D'utilisation page 22

CODE POSSIBLE CAUSE
16 Loose pulley
17 Loose flywheel
18 Carbon build-up in pump
19 Belt to tight
20 Pulley misalignment
21 Extension cord is wrong length or gauge
22 Loose electrical connections
23 Pump oil is low
24 Regulator is not adjusted correctly for accessory being
used
25 Damaged regulator
26 Detergent type oil being used in pump
POSSIBLE SOLUTION
Tighten pulley set screw, torque to 145–165 in.-lbs.
(16.4– 19.6 Nm).
Tighten flywheel screw,
(20.3– 24.4 Nm).
Contact an EMGLO factory service center or an EMGLO
authorized service center.
Check belt tension, see Adjusting Belt Tension under
Maintenance.
See Motor Pulley/Flywheel
Maintenance.
Check for proper gauge wire and cord length. See
Extension Cords under Installation.
Contact an EMGLO factory service center or an EMGLO
authorized service center.
Add EMGLO Synthetic Blue compressor oil to pump. See
Compressor Pump Oil under Maintenance.
It is normal for some pressure drop to occur when an acces-
sory is used, adjust the regulator as instructed in Regulator
under Features if pressure drop is excessive.
NOTE: Adjust the regulated pressure under flow conditions
while accessory is being used.
Replace.
Drain oil and refill pump with EMGLO Synthetic Blue
compressor oil.
22
torque to 15–18 ft.-lbs.
Alignment under