Emglo K15A-8P Guide D'utilisation page 21

CODE POSSIBLE CAUSE
4 Defective air tank
5 Leaking seals
6 Defective safety valve
7 Prolonged excessive use of air
8 Compressor is not large enough for accessory
9 Hole in air hose
10 Unloader valve restricted
11 Unit operating in damp or humid conditions
12 Restricted air intake filter
13 Loose belt
14 Pump or motor mount ing nuts are loose
15 Motor overload protection switch has tripped
POSSIBLE SOLUTION
Air tank must be replaced. Do not repair the leak.
WARNING: Risk of bursting. Do not drill into, weld or
otherwise modify air tank or it will weaken. The air tank can
rupture or explode.
Contact an EMGLO factory service center or an EMGLO
authorized service center.
Operate safety valve manually by pulling on ring. If valve still
leaks, it must be replaced.
Decrease amount of air usage.
Check the accessory air requirement. If it is higher than the
SCFM or pressure supplied by your air compressor, a larger
compressor is needed to operate accessory.
Check and replace air hose, if required.
Remove, clean or replace.
Move unit to a dry well ventilated area.
Clean or replace air intake filter.
Check belt tension, see Adjusting Belt Tension under
Maintenance.
Torque pump mounting nuts to 6– 8 ft.-lbs. (8.1–10.8 Nm).
Torque motor mounting
(11.3– 13.6 Nm). WARNING: Risk of bursting. Excessive
vibration could weaken the air tank and cause it to rupture
or explode. Mounting screws must be kept tightened.
See Motor Overload under Features.
21
bolts to 100– 120 in.-lbs.