Sony SCPH-50001/N Mode D'emploi page 34

34
Troubleshooting (continued)
, The type of network cable is not correct.
Use the correct type of cable. For details
refer to the instructions for the network
device (router, DSL modem, etc.) you are
connecting to.
, The port or settings for the network device
(router, DSL modem, etc.) are not correct.
Refer to the instructions for the network
device and make the appropriate
connections or settings.
A connection to the network cannot be
established (modem only).
, The telephone cord is not properly
connected.
Check that the telephone cord is properly
connected.
, The telephone line is already in use.
Check that the telephone line is not being
used.
, The line you are using is not a home-use
phone line.
PBX phone lines, home network and
business telephone lines cannot be used to
connect to a network.
, You are using software that can only be
used with certain providers.
Depending on the telephone company you
are using, you may not be able to establish
a connection when using software that
requires connection to certain Internet
service providers. For details, refer to the
instructions for the software in use, or
contact your Internet service provider.
The data transmission rate is slow (modem
only).
, Interference is being generated at your
location.
Do not run your telephone cord near
electronic devices such as microwave
ovens, PC monitors, TVs, radios or
speakers that generate telephone line noise.
You should also avoid using general-use
extension phone cords (audio-only type), or
cords with other phones or fax machines
connected.
, Interference is being generated at a point
between your location (home) and the
telephone company.
Use the same telephone line to call a friend
and listen for interference from radio
transmissions or other noise. Also, check
for an echo effect when you speak. If it is
clear that there is a problem with the public
telephone lines, contact your local
telephone company for assistance.
The connection suddenly fails (modem only).
, You have call waiting.
When you receive a call on a line with call
waiting, the modem may be disconnected.
Temporarily disable the call waiting
feature. Contact your local phone company
for assistance.
A connection cannot be established and,
after trying numerous times, the modem
stopped redialing (modem only).
, There are limitations on how many times a
device can dial a number. Once the
maximum number of tries has been made,
the device stops trying to redial.
Turn off the console, wait a few minutes
and then try again.
Specifications
General
Power requirements
120 V AC, 60 Hz
Power consumption
93 W
Console dimensions (approx.)
301 × 78 × 182 mm (w/h/d)
(12 × 3 × 7
1 / 1 / in)
8 4
Console weight (approx.)
2.0 kg (4 lb 14 oz)
Network adaptor dimensions (approx.)
133 x 72 x 34 mm (w/h/d)
(5 1 / x 2 7 / x 1 3 / in)
4 8 8
Network adaptor weight (approx.)
200 g (7 oz)
Operating temperature
5˚C - 35˚C (41˚F - 95˚F)
Laser diode properties
• Material: GaAlAs
• Wavelength: l=650/780 nm
Inputs/outputs on the console front
Controller port (2)
Memory card slot (2)
USB connector (2)
Inputs/outputs on the console rear
AV MULTI OUT connector (1)
DIGITAL OUT (OPTICAL) connector (1)
Expansion bay (1)
Inputs/outputs on the network adaptor
Network connector (1)
Line connector (1)
Communications options
Ethernet
Transmission standards:
100Base-TX/10Base-T compatible
Modem
Transmission standards:
ITU-T V.90, V.34, V.32bis, V.32, V.23,
V.22bis, V.21
Bell 103, 212A
K56 flex compatible
Maximum transmission rate (bps):
V.90...56K* (receive only)
K56 flex...56K* (receive only)
V.34 and others...33.6K* (send/receive)
Interface: RJ-11C
* Transmission rate may vary depending on the
condition of the line connected.
Supplied accessories
See page 8.
Optional accessories
SCPH-10010 U/97026 Analog Controller
(DUALSHOCK 2)
®
SCPH-10020 U/97027 Memory Card (8MB)
(for PlayStation 2)
®
SCPH-10030 U/97028 AV Cable
(integrated audio/video)
SCPH-10040 U/97029 Vertical Stand
(for PlayStation 2)
®
SCPH-10060 U/97030 S VIDEO Cable
SCPH-10071/94043 RFU Adaptor
SCPH-10090 U/97031 Multitap (for PlayStation
SCPH-10100 U/97032 Component AV Cable
(for PlayStation 2)
®
SCPH-10110 U/97033 Horizontal Stand
(for PlayStation 2)
®
SCPH-10130 U/97034 AV Adaptor
(with S VIDEO OUT connector)
SCPH-1020 UHI/94032 Memory Card
SCPH-1070 UH Multitap
SCPH-1100 U/94050 S VIDEO Cable
SCPH-1121/94053 RFU Adaptor
SCPH-1140 U/94055 AV Cable
(integrated audio/video)
SCPH-110 U Analog Controller
(DUALSHOCK )
®
SCPH-10420 U DVD Remote Control (for
PlayStation 2)
®
For additional parts, please call 1-800-345-7669.
Design and specifications are subject to change without
notice.
2)
®