Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connecting the network adaptor with a network cable
You can connect the PlayStation
2 console to a
®
network through the NETWORK connector on
a network adaptor installed in the
PlayStation
2 console.
®
You can connect to a 100 mbps network using
100Base-TX cable or to a 10 mbps network
using 10Base-T cable. For details, refer to the
instructions supplied with the network device
you are connecting to (such as a router, DSL
modem or cable modem).
Warning
• There is a protective sticker on the network
connector to help prevent accidental connection of
the wrong type of cable. Remove the sticker the first
time you use the network connector. After you have
removed the sticker, be careful not to connect cables
of the wrong type to the network connector.
• Do not connect network cables or telephone cords of
the following types to the network connector; too
much electrical current may pass through the
connector, causing a malfunction, excessive heat or
fire in the connector:
– Network cables of types other than 100Base-TX
and 10Base-T
– Normal telephone lines
– An ISDN (digital) compatible public phone
– A PBX phone
– A home or business telephone network phone
– Other types of telephone lines
Note
When you connect to a network, the Internet service
provider may charge a usage fee. In some cases, the usage
charges may be more than anticipated. For details, refer to
the instructions provided with the software in use or
contact your Internet service provider.
Removing the network adaptor from the console
The network adaptor can be removed from the
console. It should only be removed for the
purpose of installing an authorized expansion
bay peripheral.
Caution
• For safety reasons, turn off the console using the
main power switch on the console rear, and
disconnect the power plug for the console from the
electrical outlet before removing the network
adaptor.
• The network adaptor serves as a protective cover
for the expansion bay and the expansion bus
connector, which is located within the expansion
bay. Do not leave the expansion bay uncovered for
an extended period of time. If your network
adaptor is lost or damaged, or for any questions or
problems concerning the network adaptor, contact
our technical support line at 1-800-345-7669.
• Do not connect a commercially available hard disk
drive that is not specifically designed for the
PlayStation
2 console to the network adaptor, as
®
this may damage the console or the connected
device.
• Do not insert foreign objects into the expansion bay,
as this may damage the console or cause a
malfunction.
1
Check that the 1 (standby)
indicator on the PlayStation
2
®
console front is lit up in red, and
turn off the PlayStation
2
®
console using the main power
switch on the console rear.
2
Disconnect the power plug for
the PlayStation
2 console from
®
the electrical outlet.
3
Disconnect the telephone cord
and/or network cable from the
network adaptor.
Note
The network adaptor included in the "PlayStation
online pack/pack PlayStation
2 pour connexion en
®
ligne" is intended only for use with the
PlayStation
2 console provided.
®
4
Loosen the mounting screws.
Turn the mounting screws in a
counterclockwise direction using a
coin.
Note
Do not use a screwdriver to loosen the mounting
screws.
Mounting screw
5
Remove the network adaptor
from the console.
Remove the network adaptor by
pulling it away from the console.
Network adaptor
2
®
13
US
PlayStation
®
2
console rear
Publicité
Table des Matières
