Safety - ITW Simco-Ion Cleanflex Easy Notice D'utilisation

Pistolet à air ionisé
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3 Safety

The following safety guidelines must be observed in order to avoid injuries and damage to
objects or the Cleanflex Easy.
- Electrical installation must be carried out by a qualified electrician in accordance with
national and local regulations
- The Cleanflex Easy must not be used in a fire or explosion-hazardous environment;
- The Cleanflex Easy is intended solely for blowing and at the same time neutralizing
electrostatically charged surfaces. Any other use is not recommended
- To guarantee the service life of the Cleanflex Easy, the gun must be supplied with clean,
compressed air which is free from moisture and oil. Contamination of the high voltage
emitters will reduce the gun performance and can cause the Cleanflex to malfunction.
- A small amount of ozone is emitted during the internal ionization process. The ozone
concentration is so low that no damage to health can occur.
- When using compressed air pressure of more than 3 bar, the noise level emitted is greater
than 80 dB and hearing protection is therefore mandatory
- Do not seal the air outlet opening during use. This can create a danger of ejecting objects.
- To be protected from blown up dust or ejected objects, it is recommended to wear safety
glasses during use.
- Make sure that the equipment is properly earthed. Earthing is necessary to ensure proper
and safe operation and to prevent electric shocks upon contact;
- Never immerse or make the Cleanflex Easy wet. A short circuit will damage the gun and can
cause an electric shock
- Never use a damaged gun. Touching the live parts will cause an electric shock
- Do not insert conductive parts into the blow-out opening.
- High voltage equipment can be dangerous for people with pacemakers.
- The device loses its warranty if:
- without prior written approval, changes, adjustments, etc. have been made or non-
original parts have been used for repair;
- Dirty compressed air has been used;
- The Cleanflex internal parts have become wet and the electronics have become
defective;
- The Cleanflex has been improperly used.
CleanflexEasy_UM_9752050810_NL_D_GB_F_V1_2
GB
32

Publicité

Table des Matières
loading

Table des Matières