Table des Matières
Publicité
3.11
ACTIVATE THE PASSWORD
Enter the¡KEY¡mode to select whether the access password is
on or off. When the fixture is set as PASS ¡ON¡, after 30 seconds
or turn on the fixture next time, the fixture will need an access
password to enter the display menu control.
NOTE: The factory access password is: UP+DOWN+UP+DOWN,
then press ENTER to confirm the access.
MENU
KEY
3.12
BALANCE PARAMETERS AND CORRECTION
MENU DISPLAY
Press MENU button to enter the password confirmation, to enter the
correct password < UP + DOWN + UP + DOWN >. Key, press the MENU
in, the correct password will enter show submenu.
Enter the CALIB.C to select white color of different color tempera-
ture.There are 12 pre-programmed White colors can be edited by
using RED, GREEN, BLUE & WHITE.
When DMX mode is HSIC, CH5 can play 12 white color
When DMX mode is TOUR, CH6 can play 12 white color
When DMX mode is TR16, CH11 can play 12 white color
NOTE: if CCT data is changed in WHITE from WT.01 to WT.12, CCT of
according channel will be changed also Enter the RGBWto adjust the
RGB parameter to make different whites.
When the new setting is activated, the DMX controller choose RGB =
255,255,255 the white color will be made by the actual RGB values on
the RGBW.
MENU
CALIB. C
3.13
INFO
Press ENTER and go to INFO, you can check VERSION.
MENU
INFO
ON
OFF
****
WHITE
WT. 01
WT. 02
WT. 12
RGBW
RED
GREEN
BLUE
VERSION
RED
R. ( 0-255)
GREEN
G. ( 0-255)
BLUE
B. ( 0-255)
WHITE
W. ( 0-255)
R. ( 0-255)
G. ( 0-255)
B. ( 0-255)
29
Publicité
Table des Matières
