Table des Matières
Publicité
2.0
INSTALLATION
2.1
MOUNTING
HANGING:The fixture can be
mounted in a hanging position
using the supporting bracket.
The bracket should be secured
to the mounting truss or struc-
ture using a standard mount-
ing clamp. Please note that
when hanging the unit a safety
cable should also be used.
UPRIGHT: The fixture can
be mounted in an upright
or sitting position using the
supporting brackets.
NOTE!
The LED MODULE can be mounted at any angle and in any position.
It is possible to further adjust the angle of the LED MODULE using
the two adjustment knobs located on the side of the fixture.
2.3
POWER CONNECTIONS
220~240V: 11 units may be connected in series
110~120V: 5 units may be connected in series
NOTE!
If the signal cable is over 60 m between the DMX512 controller
and fixture or beween two fixtures, then a DMX signal amplifier is
needed as well.
23
Publicité
Table des Matières
