Reverse Door Swing (Optional); Wine Cellar Doors - Whirlpool W10739679 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Tool Needed: #2 Phillips screwdriver
Remove Door and Hinges
1. Open the door to a 90° angle and remove the screws for the
bottom door hinge.
2. Remove the door by pulling it forward and away from the wine
cellar.
3. Remove the three screws from the top hinge and remove the
hinge.

Reverse Door Swing (optional)

NOTE: There are two hinges for reverse door installation, one for
a right-hand door swing and one for a left-hand door swing.
Install the top hinge designed for the desired door swing.
1. Remove the two screws attaching the bottom hinge to door.
C
2. Remove the door by lifting it up, and then pulling it away from
the wine cellar.
3. Remove the three decorative screws from the upper left
corner of the front of the wine cellar.
4. Remove the three screws from the right top hinge, and then
remove the hinge.
5. Using the three screws removed in the previous step, attach
the left top hinge to the upper left corner on the front of the
wine cellar.
NOTE: The left hinge is included in the bag with the "Use and
Care Guide."

Wine Cellar Doors

B
A
A. Bottom hinge pin
B. Door stop
C. Bottom hinge
6. Insert the three decorative screws removed in Step 3 into the
three holes in the upper right corner of the front of the wine
cellar.
7. Remove the screws for the mechanical switch and door stop;
remove the mechanical switch and door stop. Attach the
mechanical switch and door stop to the reverse side of the
door.
NOTE: The screws for the mechanical door switch are located
behind the seal. Remove the seal first, and then remove the
mechanical door switch screws. After reattach the mechanical
door switch, place the seal in the original position.
8. Remove Whirlpool badge. (Only models: WUW55X24HS)
9. Attach the bottom hinge to the reverse side of the door, and
then flip the door 180º so that the hinge is now on the bottom
of the door.
10. Insert the top corner of the door into the top hinge pin and
reinstall the door on the wine cellar.
11. Press the door and the bottom hinge pin onto the bottom
hinge.
7

Publicité

Table des Matières
loading

Table des Matières