Wine Racks; Stocking The Wine Cellar - Whirlpool W10739679 Guide D'utilisation Et D'entretien

Wine Racks

Remove and Replace the Top and Middle Racks
To Remove Racks:
1. Pull the rack forward until it stops.
2. Lift up on both sides of the rack to clear the shelf brackets
from the bracket support pins.
3. Pull the rack forward and out of the rack supports.
To Replace Racks:
1. Insert the rack into the compartment and slide it toward the
rear of the wine cellar.
2. Align the bracket support pins with the holes in the shelf
brackets, and then place the shelf into the rack supports until
properly in place.

Stocking the Wine Cellar

NOTE: For optimum wine storage, place white wines at the top of
the wine cellar, light red wines in the center and red wines at the
bottom.
To Stock the Wine Cellar
1. Start stocking the wine cellar with the bottom display rack.
2. Starting on the left-hand side, place the first bottle in the rack
on its side with the neck of the bottle facing the front of the
wine cellar.
3. Place the next bottle on its side with the neck of the bottle
facing the back of the wine cellar.
4. Alternate in this manner until the display rack is full.
5. Push the rack all the way in before pulling the next one
forward.
6. Pull the next rack forward and repeat steps 2 through 4;
repeat for remaining racks.
Front of rack
11