Ryobi RY40806 Addendum

WARNING:
This insert sheet is not a substitute for reading the operator's manual.
To reduce the risk of injury, user must read and understand operator's
manual before using this product. All page references refer to the
operator's manual.
ADJUSTING THE HANDLE ADJUSTMENT LEVER
See Figures 1 - 2
After unfolding the handle assembly as described on page 7 of your
operator's manual, if the handle adjustment levers will not lock securely,
the nuts on the inside of the levers need to be tightened.
 Move the handle lock levers to the unlocked position.
 Tighten the nuts using the included 12 mm wrench until the handle
adjustment levers will close securely in the locked position.
NOTE: Do not overtighten. The handle adjustment levers should not
require excessive force when placing them in the locked position. If
they are too tight, loosen the nuts slightly until the levers will lock.
 Move the handle adjustment levers to the locked position to secure
the handle in place.
Please consult your operator's manual for further information or contact
RYOBI Customer Service at 1-800-860-4050.
995000934
6-5-19 (REV:01)
RY40806
ADDENDUM
ADDENDA / APÉNDICE
Fig. 1
A
Fig. 2