Publicité
MOUNTING AND ADJUSTING THE LOOP HANDLE
1. Push the loop handle onto the shaft, push the upper and lower parts together, tight the handle by rotating the
loop handle knob in clockwise direction (Fig. 12&13).
2.
Loose the knob on handle so that you can easily move/rotate the loop handle to where you feel
comfortable.
MOUNTING AND ADJUSTING THE BIKE HANDLE
1. The bike handle is preinstalled onto the tool, loosen the adjustment knob and adjust the handle as below
position
2. Install the spring and tighten the knob, the knob is tool-less. Then the bike handle installation is complete.
WARNING:
Do not use the tool without the loop handle or bike handle securely attached.
OPERATION
WARNING:
Do not allow familiarity with this product to make you careless. Remember that a
careless fraction of a second is sufficient to inflict serious injury.
Fig.12
12
Fig.13
Publicité
