Frigelux RDP91BE Manuel D'utilisation page 35

▪
Keep the door open to prevent odors from rising.
Energy saving tips
▪ The refrigerator should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight.
▪ Let hot foods cool to room temperature before placing in the refrigerator. Overloading
the refrigerator forces the compressor to run longer. Foods that freeze too slowly may
lose quality, or spoil.
▪ Be sure to wrap foods properly, and wipe containers dry before placing them in the
refrigerator. This cuts down on frost build-up inside the refrigerator.
▪ Refrigerator storage bin should not be lined with aluminum foil, wax paper, or paper
toweling. Liners interfere with cold air circulation, making the refrigerator less efficient.
▪ Organize and label food to reduce door openings and extended searches. Remove as
many items as needed at one time, and close the door as soon as possible.
Replacing light
This appliance consists of light-emitting diodes (LEDs). This
type of diode cannot be changed by the consumer. The lifetime
of these LEDs is normally sufficient for no change to be made.
If however, and despite all the care taken during the
manufacture of your appliance, the LEDs were defective, please
contact your after-sales service for any intervention.
Door reversal instructions
Depending on your needs, you can change the opening side of the door. You can choose to open
it from the right or from the left. To change the opening side, follow the instructions.
Warning:
• Before changing the opening side of the door, turn the appliance off and unplug it
from the mains.
• Any removed part must be kept until the end of installation.
• Do not lay the device down on the floor, you could damage the cooling system.
If the appliance is placed on its back or side for any length of time during this process, it must
be allowed to remain upright for 6 hours before plugging it in to avoid damage to the internal
components.
1. Remove the hinge cover and upper hinge from the top
right side of the appliance. Remove the screw hole cover
from the top left side of the appliance.
2. Remove the freezer door from the appliance. Move the
hinge plug from the top left to the top right side of the
door.
35