Preparing The Product For Use; Replacing The Battery; Operation; Weighing - SilverCrest HG01939A Instructions D'utilisation Et Consignes De Sécurité

Preparing the product for use

Pull out the insulation strip from the battery com-
partment .
5
Replacing the battery (Fig. C)
Loosen the screw located at the back of the
product.
Open the battery compartment
the product.
Remove the used battery, if present.
Insert a battery type CR2032 in the battery
compartment .
5
Note: Make sure you insert the batteries with the
correct polarity. This is indicated on the cover of
the battery compartment.
Close the battery compartment
screw.

Operation

Set the product on a solid, level and flat surface to
weigh.

Weighing

Note: Always place the object you wish to weigh
gently onto the weighing surface
ing the glass surface.
Briefly touch the button
the product. The LC display
plays for approx. 3 seconds.
Note: A slight touch of the button
and the button UNIT
product. If there is too much pressure, the product
may cause tilting.
on the back of
5
and tighten the
5
to avoid damag-
1
/ TARE to switch on
3
will show all dis-
2
/ TARE
is sufficient to operate the
4
During this time the weighing equipment on the
product is adjusting. Afterwards the numerical dis-
play will read „0". The unit display
10
show the last unit selected.
Note: if an object (e.g. a key) is already on the
weighing surface
numerical display
Place the item you wish to weigh onto the product.
The numerical display
the item you are weighing.

Incremental weighing

Touching the button
on will change the numerical display
reading to „0". The „Tare" symbol
Now add another item to weigh onto the product.
The numerical display
the newly added item.
If you remove the item added to the product, the
numerical display
If you remove all items from the product, the LC
display
2
by the minus symbol
Then briefly touch the button
the „Tare" symbol
Important! Be sure never to add more than 5 kg
to the weighing surface
product can damage it.

Changing the measuring unit

The product will display the weight in the official Euro-
pean measuring unit „g" (grams), as well as the tradi-
tional unit of weight „oz" (ounce, 1 oz ≈ 28.35 g) or
3
„lb'oz" (pound: ounce, 1lb = 16 oz ≈ 453.59 g).
When measuring the volume of water, the product cal-
culates it by the weight using the official European unit
while switching on, the
1
will still read „0".
10
will show the weight of
10
/ TARE with the product
3
will show the weight of
10
will again read „0".
10
will show a negative value indicated
.
8
/ TARE
will disappear.
9
. Overloading the
1
will
11
from the
10
will appear.
9
, and
3
GB/IE 17