Sony SU-WL500 Manuel D'installation page 6

2
Referring to the Screw and Hook
locations diagram/table on
page 28, determine the screw
positions, and secure the
Mounting Hook to the rear of the
LCD Display.
 Attach Wall-Mount Attachment (supplied
with the LCD Display) to the rear of the LCD
Display (to make it parallel with the wall).
Supplied with the
LCD Display
Wall-Mount
VS
Attachment (4)
Note
• Be sure to fasten the Wall-Mount Attachment when
attaching them to the LCD Display. Use only a flat
head screwdriver to install the Wall-Mount
Attachment. Use of another tool might result in
over torqueing the Wall-Mount Attachment and
damaging the LCD Display.
 Secure the Mounting Hook to the rear of the
LCD Display temporarily, using the four
screws (+PSW6 × 25).
Note
• Be sure that both screws are securely tightened
with equal torque strength to the rear of the LCD
Display.
6
(US)
1.5 N·m
{15 kgf·cm}
VS
Mounting Hook
1
* Screws (+PSW6 × 25) (not supplied)
(SONY Part Number 4-577-326-01) × 4 (1 pk)
2
* Needs 5 spacers (not supplied) with an outside
diameter of 18 mm, inside diameter of 10 mm, and
thickness of 2 mm.
(SONY Part Number 7-688-000-32) × 20
3
Make sure that the screw 
firmly secures the arm base of
the Mounting Hook (both left
and right).
Note
• Make sure that the two arms are screwed in
securely.
2
*
10 mm
1
Screw*
(+PSW6 × 25)