Sony SU-WL500 Manuel D'installation page 11

2
Referring to the Screw and Hook
locations diagram/table on
page 28, determine the screw
positions, and secure the
Mounting Hook to the rear of the
LCD Display.
 Attach Wall-Mount Attachment (supplied
with the LCD Display) to the rear of the LCD
Display (to make it parallel with the wall).
Supplied with the
LCD Display
Wall-Mount
VS
Attachment (4)
VS
Note
• Be sure to fasten the Wall-Mount Attachment when
attaching them to the LCD Display. Use only a flat
head screwdriver to install the Wall-Mount
Attachment. Use of another tool might result in
over torqueing the Wall-Mount Attachment and
damaging the LCD Display.
 Secure the Mounting Hook to the rear of the
LCD Display temporarily, using the four
screws (+PSW6 × 25).
Note
• Be sure that both screws are securely tightened
with equal torque strength to the rear of the LCD
Display.
1
*
2
*
1.5 N·m
{15 kgf·cm}
2
*
Mounting Hook
Screws (+PSW6 × 25) (not supplied)
Needs 5 spacers (not supplied) with an outside
diameter of 18 mm, inside diameter of 10 mm, and
thickness of 2 mm.
10 mm
1
Screw*
(+PSW6 × 25)
11
(US)