Sony HT-A5000 Mode D'emploi page 52

[Speaker Settings] - [TV Center
Speaker Settings] - [TV Center Speaker
Mode] to [On], the center part of the
speaker system sound is output from
the TV. For detail, refer to Help Guide.
The TV sound from this speaker
system lags behind the image.
 Set the adjustment value of the delay
between the picture and sound to 0
msec if it is set to the range between
25 msec and 300 msec. For details,
refer to Help Guide.
 A time gap between the sound and
picture may occur depending on the
sound source. If your TV has a
function that delays the image, use it
for adjustment. For details, refer to
the operating instructions of your TV.
No sound or only a very low-level
sound of the device connected to
the speaker system is heard.
 Press  (volume) + on the remote
control and check the volume level
(page 12).
 Press  (muting) or  (volume) + on
the remote control to cancel the
muting function (page 12).
 Make sure the input source is selected
correctly. You should try other input
sources by pressing the input select
button on the remote control (TV/
HDMI/USB/BLUETOOTH).
 Make sure that the connectors are
firmly inserted.
 When you play content compatible
with copyright protection technology
(HDCP), sound may not be output
from the speaker system.
 Change the setting of
[Advanced Settings] - [HDMI Settings]
- [HDMI Signal Format] - [HDMI IN]. For
details, refer to Help Guide.
The surround effect cannot be
obtained.
 Depending on the combination of the
setting of SOUND FIELD (page 37) and
input signal, surround sound
processing may not work effectively.
52
US
 To play multi-channel audio, check
Sound is not output from some
speakers.
 Depending on the combination of the
Sound Field Optimization
Sound Field Optimization failed.
 When using the optional rear
 Perform Sound Field Optimization
 If the distance between the bar
 If there is any obstacle between
[Setup] -
The surround effect may be subtle,
depending on the program or disc.
the digital audio output setting on the
device connected to the speaker
system. For details, refer to the
operating instructions of the
connected device.
setting of SOUND FIELD (page 37) and
sound source, some speakers may not
output sound.
speakers, install them upright so that
the labels on the bottom of the
speakers are directed downwards.
again in a situation where the
surrounding is quiet.
speaker and optional rear speakers/
subwoofer is too close or far away
from each other, Sound Field
Optimization cannot be performed
properly. Adjust the distance between
speakers and perform Sound Field
Optimization again.
speakers or the microphone for
measurement of the speaker is
blocked by an obstacle, Sound Field
Optimization cannot be performed
properly. Remove it if there is any
obstacle between speakers or in front
of speakers.