Heater Stand And Location; Gas Requirements - Sunred Gh12-Rvs Manuel

HEATER STAND AND LOCATION

● The heater is primarily for outdoor use only. Always ensure that adequate fresh air
ventilation is provided.
● Always maintain proper clearance to combustible materials, i.e. top 45cm(18") and
sides 70cm (28") minimum.
● Heater must be placed on level firm ground.
● Never operate heater in an explosive atmosphere like areas where gasoline or other
flammable liquids or vapors are stored.
● To protect heater from strong wind, anchor the base securely
to the ground with screws.
● Water tank should be full of water or sand. Otherwise heater would filt.

GAS REQUIREMENTS

● Use LPG gas mixtures .
● Maximum inlet pressure of propane regulator must not exceed 100 PSI.
● The pressure regulator and hose assembly to be used must conform to local standard codes.
● The installation must conform to local codes, or in the absence of codes, with standard codes.
● The installation must conform to local codes, or in the absence of codes, with the standard for storage and handling of liquid petroleum
gases.
● A dented, rusted or damaged propane tank may be hazardous and should be checked by your tank
Never use a propane tank with a damaged valve connection.
● The propane tank must be arranged to provide for vapor withdrawal from the operating cylinder.
● Never connect an unregulated propane tank to the heater.
All manuals and user guides at all-guides.com
www.sunred.nl
Ceiling
(28'')
70cm
supplier.