Husqvarna 525HE3 Manuel D'utilisation page 14

WARNING:
cutting unit when you adjust the
angle.
1. Let the engine run at idle speed and make
sure the cutting unit does not move.
2. Pull down the position adjustment handle.
3. Tilt the cutting unit to the correct position.
Use 1 of the procedures that follow.
a) Use the handle.
b) Push the end of the cutting unit against
a stable surface.
4. Release the position adjustment handle to
lock the cutting unit.
5. Push the cutting unit against the hedge to
make sure that it is locked.
14
Do not operate the
To adjust the friction for angle adjustment
WARNING:
cutting unit when you adjust the
friction.
1. Push the stop switch to stop the product.
2. Install the transport guard on the cutting
unit
3. Pull down the position adjustment handle.
4. Tilt the cutting unit to the applicable
position.
5. Adjust the screw to set the friction.
6. Set the cutting unit in different positions to
try the friction.
To set the product in transport position
WARNING:
product when the product is in
transport position.
1. Push the stop switch to stop the product.
2. Install the transport guard on the cutting
unit.
3. Pull down the position adjustment handle.
Do not operate the
Do not start the
1173 - 001 -