Tecno-gaz Orma Mode D'emploi page 23

ENGLISH

Locate the coiled film into the case of the machine horizontally.

Press the film head with one hand and push it into the film outlet
medially.

At the same time, hit
machine until the film is positionated.

Press the footboard once, the film will be automatically sent out to working
location.If need to adjust remain of the coiled film, please see:"Reset Remain".
If it does not work, press

When the coiled film is located in the working position, the machine van be
used.

Step on the position with "PRESS" mark.

When five digits on the screen are lit and a long "beep" sound is produced, the
shoe cover is shaped.

Please leave your foot from the footboard, by the time, the film will
automatically stretch out for next usage.

If necessary press to close the machine.
About the set up of the machine refers to LCD screen and four function keys. Trough
the function keys to implement three basic functions:"Shoe Covering", "Warm Wind"
with another hand and send the film into the
to turn back the film and repeat the above steps.
6