Publicité
Les langues disponibles
Les langues disponibles
FUNCTIONAL DESCRIPTION
1.
5 V DC USB receptical
2.
Access door
3.
12 V DC receptical
4.
Fuel Gauge
Continuous light:
Full charge
Slow-blinking light:
Partial charge
Fast-blinking light:
Low/no charge
W
Watts
Volts Direct Current
Volts Alternating Current
Specifi cations
Input
Output
Input
Output
Cat. No.
Volts
Amps
Volts
Amps
2349-20 *
12 DC
3 A
12 DC
* Uses MILWAUKEE 48-11-2401 Li-Ion battery packs.
4
3
Symbology
CM
Intertek Electrical Testing Labs
C
US
Intertek
Amps
mA
Milliamps
Output
USB Output
USB Output
Watts
Volts
Amps
3 A
36 W
5 DC
750 mA
4
WARNING
charger specifi ed for the battery. For specifi c
charging instructions, read the operator's
1
manual supplied with your charger and
battery.
2
Inserting/Removing the Battery
To remove the battery, push in the release but-
tons and pull the battery pack away from the
power port.
To insert the battery, slide the pack into the body
of the power port. Make sure it latches securely
into place.
OPERATION
WARNING
pack before changing or removing acces-
sories. Only use accessories specifically
recommended for this tool. Others may be
hazardous.
Fuel Gauge
To determine the charge of a battery pack, insert the
battery pack into the power port. The Fuel Gauge
will light up for 2-3 seconds:
Continuous light:
USB Output
Watts
Slow-blinking light:
3.75 W
Fast-blinking light:
Using the Power Port
After installing the battery pack, open the access
door and plug in a 12 V Automotive or 5 V USB
powered appliance.
If the appliance draws more than the rated output of
the outlet, the power port will shut off to protect the
battery pack. To restart the power port, remove and
reinstall the battery pack. Use only appliances rated
within the output specifi cations for the port.
ASSEMBLY
WARNING
Recharge only with the
always unplug the charger and remove the
battery pack from the charger or power port
before performing any maintenance. Never
disassemble the power port, battery pack or
charger. Contact a MILWAUKEE service facil-
ity for ALL repairs.
Maintaining Tool
Keep your power port, battery pack and charger
in good repair by adopting a regular maintenance
program. After six months to one year, depending
on use, return the power port, battery pack and
charger to a MILWAUKEE service facility for:
• Electrical inspection
• Testing to assure proper mechanical and
electrical operation
Always remove battery
If the power port does not start or operate at full
power with a fully charged battery pack, clean the
contacts on the battery pack. If the power port still
does not work properly, return the power port,
charger and battery pack, to a MILWAUKEE service
facility for repairs.
WARNING
sonal injury and damage, never immerse your
11% - 100%
tool, battery pack or charger in liquid or allow
a liquid to fl ow inside them.
1% - 10%
Cleaning
< 1%
Clean dust and debris from charger and power
port. Keep power port clean, dry and free of oil
or grease. Use only mild soap and a damp cloth
to clean the power port, battery pack and charger
since certain cleaning agents and solvents are
harmful to plastics and other insulated parts. Some
of these include gasoline, turpentine, lacquer thin-
ner, paint thinner, chlorinated cleaning solvents,
ammonia and household detergents containing
ammonia. Never use fl ammable or combustible
solvents around power port.
5
MAINTENANCE
To reduce the risk of injury,
To reduce the risk of per-
Publicité
