Picking Up Liquids; Blower Function; Connecting Electrical Appliances - Makita VC2012L Notice D'utilisation D'origine

Masquer les pouces Voir aussi pour VC2012L:
Table des Matières

Publicité

D
Makita VC2012L / VC2512L / VC3011L
GB
When dust removers are used, the rate at which air is exchanged in the room must be adequate if the
F
exhaust air from the vacuum cleaner is blown into the room (please observe regulations valid in your
country).
NL
Before starting work, the operating staff must be informed on
use of the vacuum cleaner
I
risks associated with the material to be picked up
safe disposal of the picked up material
N
Operation
S
Switch position
DK
SF

Picking up liquids

E
Before liquids are picked up, always remove the filter bag. Check that the float works properly. If foam
develops or liquid emerges, stop work immediately and empty the dirt tank.
P
Cleaning the filter element
GR
If suction performance drops:
1.
Switching on the vacuum cleaner.
TR
2.
Close the nozzles or suction hose opening with the palm of your hand.
3.
Press the button to start filter cleaning for at least three times for two seconds each. The resulting
SLO
stream of air removes attached dust from the slats of the filter elements.
4.
If the suction power is too low after filter cleaning: replace filter.
HR

Blower function

E
SK
The cleaner has a blower function to clean inaccessible places or to dry the surface of wet items.
CZ
Do not direct the air into rooms in an uncontrolled manner. When using the blower function, always
use a clean hose. Stirred-up dust can be hazardous to health. Do not use the blower function in closed
rooms.
PL

Connecting electrical appliances

F
H
Use the socket on the vacuum cleaner for the purpose defined in the operating instructions only.
RO
Before plugging an appliance into the appliance socket:
1.
Switch off the vacuum cleaner.
BG
2.
Switch off the appliance to be connected.
CAUTION! Follow the operating instructions and safety instructions for appliances connected to the
RUS
power tool socket.
EST
+
Maintenance, cleaning and repair
G
H
Only carry out maintenance work described in the operating instructions. Always pull out the mains
LV
plug before cleaning and maintenance of the vacuum cleaner. Never spray water on to the upper sec-
tion of the vacuum cleaner: Danger for persons, risk or short-circuiting.
LT
The use of non-genuine spare parts and accessories can impair the safety of the appliance. Only use
spare parts and accessories from Makita.
During maintenance and cleaning, handle the vacuum cleaner in such a manner that there is no dan-
ger for maintenance staff or other persons.
18
I
0
Function
On
Off
Auto-On/Off

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Vc2512lVc3011l

Table des Matières