KLS Martin group L1 Mode D'emploi page 29

Instructions for Use
L1® storage system
Opening the screw and plate module / removal of the lid
Simultaneously press the two lateral light gray opening tabs outwards with the thumb, removing the lid.
Closing the screw and plate module / putting on of the lid
Place the lid on the two lateral, light gray tabs and press it down. The tabs snap in audibly on both sides.
Ensure that the lid is put on in the correct orientation. Observe the marking "This side up".
Removal of the screw using a screwdriver
Place the blade of the screwdriver on the screw head in perpendicular orientation. Pick up the screw by
exerting slight axial pressure and remove it from the clip.
Revision 2 29