Nikon RifleHunter 1000 Manuel D'utilisation page 9

Operational summary
5. Selecting display unit (Factory default setting is yard.)
En
Fr
Yard Meter
[ ] [ ]
Es
Pt
1. Confirm the LCD panel is on.
2. Press and hold the button for approx. two seconds.
3. When display unit has switched, release the
4. After the unit is set, results will be converted and displayed
in the your selected measurement unit.
6. Switching measurement modes (Factory default setting is
linear distance measurement mode)
Linear Distance Horizontal Distance
Mode
Mode Mode
Symbol No symbol
7-segment display Linear Distance Horizontal Distance
Linear Distance Mode
Horizontal Distance Mode
By pressing the MODE button, modes will change in the order
indicated above.
16
1. Confirm the LCD panel is on.
2. Press button within 0.5 seconds.
3. Release button to switch the mode.
4. Repeat steps 2 and 3 until your desire mode is displayed.
5. Switching the mode after measurement converts the results
to the new mode.
6. After the mode is set, measurements are performed in the
button.
new mode.
7. Switching Target priority modes
(Factory default setting is First Target Priority mode for Archer's
Choice, Distant Target Priority mode for RifleHunter 1000.)
First Target Priority
[ ]
1. LCD panel should be on.
2. Press and hold button, then depress and hold
button within 0.5 second.
Note） I f the button is not pressed within 0.5 second,
the display unit (m/yd) will be switched.
3. Continue to press and hold both buttons (more than 2
seconds) until First Target Priority mode and Distant Target
Priority mode are switched.
Note: If buttons are not pressed in the correct order,
switching will not take place.
Note: If switching fails to take place, repeat 2.
4. Release buttons.
[Deciding which Target Priority to use]
When obtaining different results from a single measuring
operation, the Nikon RifleHunter 1000/Archer's Choice MAX will
display the distance to the farthest target on the LCD panel when
using Distant Target Priority mode, while First Target Priority mode
will show the range to the nearest target.
ex.) When measuring a tree standing in front of a house;
Distance to Target
"115m" (distance to the tree) will be displayed in First Target Priority
mode, and "128m" (distance to the house) in Distant Target Priority
mode. First Target Priority mode, for example, has applications for
golf, while Distant Target Priority is useful when hunting in heavily
wooded areas.
Distant Target Priority
[ ]
8. Low battery indication
Flashing indicates that the battery power is low and
battery should be replaced. (See "Changing Battery")
Tree Fence House
115m 123m 128m
En
Fr
Es
Pt
17