Internal Display; Operational Summary - Nikon RifleHunter 1000 Manuel D'utilisation

Internal display

En
1. 『 』- Target aiming/Laser irradiate system
Fr
『 』- Aim at the target. Position the target at the center of the reticle.
『 』- Appears while the laser is being used for a measurement.
Es
(Remains present during single measurement. Blinks during continuous measurements.)
Pt
Warning: Do not look into the objective lenses when this mark is shown.
2． 『 』- Distance/measurement status display
Digitally indicates measured distance in meters or yards. Also indicates measuring
status such as "Measurement in progress", "Measurement unsuccessful" or "Unable to
measure."
<Examples of measurement results>
(Distance)
Display of results: ( ＜ 999.9m/yards) e.g. 234.9 meters = 『
Display of results: ( ≧ 1,000m/yards) e.g. 1,065 yards = 『
『 』Now measuring
『 』Failure to measure or unable to measure distance
3. 『 』Display units
『 』Indicates distance being measured in meters.
『 』Indicates distance being measured in yards.
4. 『 』Indicates battery condition. (See "Changing Batteries")
5. 『 』Display modes
A. Horizontal Distance Mode
『 』 C alculates horizontal distance to your target by measuring the linear distance and angle, and displays the
results.
B. Linear Distance Mode
『 (no sign) 』 Calculates linear distance to your target and displays the results.
6. 『 』Target Priority mode
First Target Priority mode
『 』Indicated when First Target Priority mode is set.
Distant Target Priority mode
『 』Indicated when Distant Target Priority mode is set.
12
』
』
7. Active Brightness Control Viewfinder
Active Brightness Control Viewfinder detects light conditions
of the ground area mainly in the view field and, when
necessary, automatically turns on the orange LED illumination.
The brightness of the orange illumination is adjusted
automatically according to the light conditions.
Although the LCD was produced using the most advanced
technology, it is impossible to eliminate dust completely.
When using this product, the LCD is magnified by high
magnification of the eyepiece lens and dust may appear as a
defect. It will not, however, affect measurement accuracy.

Operational summary

Caution — use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous radiation
exposure
1. Install a battery in the battery chamber. (See "Changing
Batteries")
2. Rubber eyepiece cup
Both eyeglass wearers and non-wearers can use this
rangefinder without attaching the rubber eyepiece cup.
3. Diopter adjustment
Adjust diopter to obtain a clear image in the LCD.
First, rotate the diopter adjustment ring counterclockwise
until it comes to a complete stop. Next, turn on the power
to activate the LCD when you look through the Nikon
RifleHunter 1000/Archer's Choice MAX. Rotate the diopter
adjustment ring clockwise until the display comes into focus.
If the diopter is not adjusted to correspond to your
eyesight, you may not be able to aim your subject.
En
Fr
Es
Pt
13