Tecno-gaz DAQF028 REV0.10 Mode D'emploi page 24

TECNO-GAZ
2.4 Detergent dispenser.
The use of "MEDICLEAN" detergent manufactured by DR.WEIGHERT – Germany is recommended as the machine was tested
by this company.
•
The liquid detergent dispenser is a standard fitting on the machine. The quantity of detergent supplied can be adjusted by
following the directions given in paragraph 8.2.
•
The default values correspond to the percentage recommended by the detergent manufacturer for an average consumption of
•
10 cc. per cycle
•
The maximum permitted quantity per wash cycle is 25cc which corresponds to 60sec. on the programme setting.
•
Warning: the machine is fitted with a gauge that sends a warning signal when the detergent runs out.
•
The machine is fitted with a 500cl. detergent compartment in the panel below the door as part of standard supply.
WARNING
To ensure the efficiency of the dispenser pumps for chemical products it is
important to service them regularly as described in paragraph 10.
2.5 Connecting the discharge pipe.
•
The discharge pipe connection should be checked carefully.
•
A 28mm discharge fitting is present on the back of the machine.
•
Use a discharge pipe suitable for organic and chemical materials and hot liquids.
•
Caution: if the discharge pipe is clogged take great care when processing the water and avoid contact with hands,
eyes, etc. In the case of contact rinse the parts concerned with plenty of water.
2.6 Water softener built-in
The water softener built-in function is to reduce the anti-limescale quantity contained into the inlet water. If
the machine is connected with hard water, the result is a rapid degeneration with lost in functions and
perfomances. Regeneration must be done in order to mantain active ionic resins.
For machines equipped with water softener, when installed, water hardeness value
must be introduced entering into programmation (PRG switch 5 seconds) with password 100, at Parameter
P16 and introduce one of the following values:
Value 10 : NO REGENERATION
Value 20 : REG. every 25 cycles
Value 30 : REG. every 18 cycles
Value 40 : REG. every 12 cycles
Value 50 : REG. every 6 cycles
Value 60 : REG. present at each cycle (it is recommended for authorized people only).
The machine advise that it need a regeneration with a written on diplay " CLN" or "RIG"
Actions:
- Open the door
- Unscrew the plastic cap of salt box
- Spill 0.5Kg of common salt inside the box by using the appropriate funnel. WARNING: during this
operation, pay attention do not let fall sail outside box
Closed the plastic cap.
-
After having introduce the basket, start with a normal washing cycle.
Machine regenerates automatically
WARNING: washing cycle made after "CLN" will be longer and it seems that machine doesn't work.
24
(French degrees )
DAQF028_rev0.10