Tecno-gaz DAQF028 REV0.10 Mode D'emploi page 22

TECNO-GAZ
It is important to keep this instruction manual with the machine for future reference. If the machine is sold or transferred, the manual
must be handed over to the new owners or user in order for them to become acquainted with its functioning and the relative warnings.
The purpose of the warnings is to safeguard the user in compliance with directive 93/42 with incorporated in the "Harmonised Technical
Product Standards " EN 61010-1 AND EN 61010-2-45
Read the warnings carefully before installing and using the machine.
1.1 Safety recommendations.
If the new machine appears to be damaged, contact the retailer before starting it.
-
- Any modification of electrical and hydraulic systems necessary to install the machine must be carried out by qualified, authorised
persons only.
- This machine must be operated by trained persons only;
- The machine was designed for washing, receptacles, kidney bowls, drainage collection bottles disinfecting and other receptacles
used in hospital wards, nursing homes, old-peoples homes.
- Any use other than that for which the machine was intended is forbidden.
- The user is forbidden to carry out any work or repairs on the machine.
- Technical Assistance for this machine should be carried out by qualified and authorised operators only.
- The equipment should be installed by authorised persons only.
- Do not install the equipment in rooms where there is the risk of explosion.
- Do not expose the equipment to intense cold.
- The electrical safety of this machines is only guaranteed if it is connected to an efficient earth system.
Take great care when handling detergents and additives: avoid contact, wear gloves and act in compliance with the safety
-
recommendations indicated by the manufacturer of the chemical products.
- Do not inhale the fumes produced by chemical products.
WARNING: the chemical products are an irritant for the eyes, in case of contact rinse
thoroughly with plenty of water and consult a doctor. If these products come into
contact with the skin, rinse with plenty of water.
- The water in the tank is not drinking water.
- Do not lean on the door and do not use it as a step.
The machine reaches a temperature of 95°C during the work cycle: take great care to avoid burns.
-
- Do not wash the machine using high-pressure jets of water.
- Disconnect the machine from the electrical supply before carrying out maintenance work.
- The acoustic pressure of the machine is below 70dB (A).
1.2 Recommendations to ensure high quality performance
•
When the machine is running do not interrupt the cycle since this jeopardises disinfection.
•
Check periodically using chemical indicators to ensure correct disinfection.
•
Use recommended detergents and chemical additives only. The use of other products may damage the machine.
•
Recommending chemical additives does not make the manufacturer responsible for any damage to the materials and
objects treated.
•
Follow the manufacturer's indications when using chemical products and use them for the foreseen use only.
•
The machine was designed for use with water and chemical additives. Do not use organic or other types of solvent as
this may result in the risk of explosion or the rapid deterioration of certain machine parts.
•
Residues of solvents or acids, particularly "hydrochloric acid", can damage steel. Contact should be avoided.
•
Use original accessories only.
•
Do never use soap powder.
•
Do never use foaming detergent.
•
Do never use chemical products based on chlorides (bleaches, sodium hypochlorite, hydrochloric acid and so on).
These kinds of chemical detergents irreparably damage the machine and jeopardise the integrity of materials and
objects treated.
The manufacturer declines all responsibility for personal injury or material damage
resulting from the non-observance of the above rules.
The non-observance of these rules produces the total and prompt cancellation of the guarantee.
22
.
DAQF028_rev0.10