Built-In - ROSIERES VG 40 Notice D'emploi Et D'installation

If any soil remains, repeat the steps listed above. For additional protection, after all soil has
been removed, polish the entire surface with the cleaning cream. Buff with a dry paper towel.
Any product for cleaning glass is also a good protection.
N.B. :
Do not use a sponge that is excessively wet.
Never use steel tools such as knives or screwdrivers.
If you want to take the knobs off for a full cleaning, take care not to let water go into the
open zone, and then check carefully that you completely re-seat the control knob.
Using a razor scraper will not damage the surface if the 30° angle is maintained.
Do not leave the razor scraper within reach of children.
___________________________________________________________________________
INSTALLATION - BUILT-IN
___________________________________________________________________________________
The cabinet in which your hob will be installed and all adjacent furniture, should be made of
materials which can withstand temperatures of up 100°C. In addition, all decorative lami-
nates must be fixed with the heat-resistant glue.
Take care to keep a minimum 5 cm between the appliance and adjacent furniture.
To ensure proper ventilation around the hob, allow at least 1 cm between the underside of the
hob and the cabinet, and a 10 x 10 cm opening as illustrated.
When placing the hob, make sure that the joint (fiited with the hob) between the surrounding
edge of the appliance and the worktop is properly sealed and that spillages cannot leak into any
gap.
Worktop cut-out dimensions :
Length 560 mm
Width 490 mm

Built-in :

Type "X" installation
conforms to CEI 335.2.6
10 x 10 cm
opening for
supply cable
and
ventilation
- 21