Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Fit the drawers inside the machine and position
the container under the spout.
The display will show the following animation.
CONNECT TUBE TO TRAY
Check that the tube is connected to the hole
located on the drop collecting grid.
Press the MULTIFUNCTION button
confirm.
During the the rinse cycle, the display will show
the following animation.
During the rinse cycle, the machine sets au-
tomatically in pauses to allow emptying the
container.
At the end of the delivery, the rinse cycle is
completed.
Remove the drop drawer and the exhausted
pod drawer, then empty the container used for
rinsing.
28
MACHINE MENU
CLEANING
The "Clean" function allows to start the ma-
chine washing cycles.
➤
➤
➤
➤
➤
➤
Frother rinsing
The "Frother rinsing" function allows to start
milk module cleaning.
The frother rinsing function must always be
performed after a milk-based beverage has
been prepared.
to
Follow the instructions shown on the display to
complete milk tube rinsing.
The display will show the following animation.
Connect the tube to the drop drawer through
the hole located on the drop collecting grid.
Place a large container under the spout.
Frother rinsing
Brew unit rinsing
Clean milk spout
System filling
Back
Exit
CONNECT TUBE TO TRAY
Publicité
Table des Matières
