System Settings - Fysic FX-8025 Mode D'emploi

10 SYSTEM SETTINGS

10.1 INTRODUCTION:
The system settings are the settings regarding the general functioning of
the FX-8025, i.e. not specifically for the wired telephone of wireless hand-
set. You can use the wired telephone or wireless handset to fully custom-
ize these settings according to your preferences.
10.2 TIME AND DATE:
In standby, the display of the telephone and handset shows the time and date.
In case of Caller-ID service and when recording messages in the answering
machine, the time and day of the call are registered. You only need to program
the time and date in the telephone or in the handset once.
Attention: when connected to a switchboard sending Caller-ID with FSK sig-
nals, you'll receive the time and date from that switchboard by simply waiting
for a while until you receive an incoming call.
SEE FOLD-
OUT PAGE
select the option:
press the OK button and use the
tons to set the correct year
now repeat this instruction for the following:
the month
the date
the hours
the minutes
press the OK button; after a whistle tone, your
settings are saved
press the End button to leave the setup mode
187
and but-