Possible Problems And Solutions - Fysic FX-8025 Mode D'emploi

14 POSSIBLE PROBLEMS AND SOLUTIONS

14.1 PROBLEMS WITH OUTGOING CALLS:
• There's no dialling tone.
- The outside line is being used by (one of) the wireless handset(s).
Wait until that call is finished and try again.
- Check the connection between the base and your telephone
connection (when in doubt, connect a different telephone to your
telephone connection).
• The power supply is lost.
- Check whether the adaptor is plugged into the back of the phone
and make sure the power adaptor is plugged into a wall socket
marked with 230V (you can check this by e.g. connecting a floor
lamp to that wall socket).
14.2 PROBLEMS WITH INCOMING CALLS:
• No notification of incoming calls:
- The bell is disabled; enable it. (see paragraph 11.1)
- Check the connection between the phone and your telephone
connection (when in doubt, connect another telephone to your
telephone connection)
• You are continuously busy:
- Check whether you have a 2nd phone with its receiver next to the
phone.
- Check whether (one of) the wireless handset(s) registered to your
telephone is keeping the line busy.
- Connect another phone to your phone connection, and use this to
check whether the malfunction originates from your connection or
your carrier.
14.3 PROBLEMS DURING CALLING:
• Beep tones during an intercom call:
- You are called from outside during an intercom call; end this call,
wait until the phone rings normally and answer the call.
204