Caller Identification - Fysic FX-8025 Mode D'emploi

7

CALLER IDENTIFICATION

7.1 INTRODUCTION:
If you have the service Caller Identification at your disposal, the number of
the calling party is displayed on the display of your handset(s). You have
programmed this number including name and the phone book memory of
the handset, the name is also displayed on the display.
7.2 NEW CALL INDICATION:
The word NEW will appear in the display when the memory contains calls you
haven't seen yet. Following the word NEW, the number of new calls you've
received since the last time you checked the memory is shown.
7.3 CHECKING THE MEMORY:
repeatedly press the
the Caller-ID memory
* in the upper right corner, after #, the number
of this call is shown
* in the middle upper part of the display, the
time and date of the call are shown
* if the word RPT appears while checking the
memories, it means that this subscriber has
called you multiple times since the last time
you checked the memory (this indication only
appears when the selected call a new call is,
i.e. not yet read)
press the End button to leave the memory read-
ing mode
173
and buttons to scroll