Declaration Of Conformity - Fysic FX-8025 Mode D'emploi

14.6 OTHER:
• The wired telephone emits a beep tone every 60 seconds:
- This is a notification to tell you that new messages are registered in
the answering machine. After listening to these messages, the beep
tone will stop. You can also disable this function according to the
instructions in paragraph 8.7.
- The display stays blank:
- The batteries are empty, please recharge them.
• The handset is not connected with the telephone:
- You're out of range from the telephone; move closer.
- The handset is switched off. Check and switch on.
- the handset is not (no longer) registered on the telephone; please
register/re-register (see paragraph 12.2).
In case the failure has not been solved with aforementioned solutions:
• Remove the batteries from the handset, and unplug the power
supply adapter and the phone connector from their sockets; connect
everything again after several minutes.
You can also contact the Fysic service center on phone number +31 (0) 73
6411 355 of with the supplier of this phone.

15 DECLARATION OF CONFORMITY

This device meets the essential requirements and other relevant
provisions as stipulated by the European Guideline 1999/5/EC.
The declaration of conformity is available on the website
http://DOC.hesdo.com/FX-8025-DOC.pdf
206