Hauff-Technik HSI 150-K2/240 Instructions De Montage page 17

HSI 90/HSI 150. How to set in concrete correctly.
Installation: Preparing to install the system cover/system seal
• Do not open the blind cover of the wall insert until just before installing the cable. Observe
the installation instructions for the system cover.
• Any cable entries that are not required may be used as pressure-tight back-up entries if
there is an undamaged Hauff quality seal on the closing cover.
• Do not knock the blind cover in with a hammer or sharp object!
• Open cable entries, which are to be used as back-up entries, or closing cover which have been
opened accidentally, should be fitted with new HSI 150-D respectively HSI 90-D blind covers.
• Do not reuse uninstalled or damaged closing covers!
Remove protective foil from the wall insert (after warming
1
slightly).
If necessary, clean out concrete residue from the wrench
threads on the black blind cover.
Use the SLS 6G(D) flexible socket wrench to open the blind
cover via the wrench threads by twisting to the left.
With single wall inserts HSI 150 with wall thickness 70 to
2
150 mm, the safety cover (second sealing cover) on the
connection side (bayonet mounting) is tapped in with
a hammer and removed. Optionally, the safety cover can
also be tapped in on the rear side.
The lamella plug is then removed on the pipe side
(HSI 150-K70 and -K80 without lamella plugs).
When tapping in the safety cover (second sealing
cover), the bayonet mounting and the seal seat for
the O-ring of the seal packing must not be damaged.
Service telephone +49 7322 1333-0
As indicated in the instructions for use, our products have been designed exclusively for in-
stallation in buildings made from state-of-the-art construction materials. We do not accept
liability for use deviating from or beyond this unless our express written confirmation has been
obtained in advance.
Lamella
plugs
Connection side
(bayonet)
17
EN
Safety cover
(second seal)
Subject to change.