Hauff-Technik HSI 150-K2/240 Instructions De Montage page 15

HSI 90/HSI 150. How to set in concrete correctly.
Installation: Using example HSI 150-K2 double wall insert
• Single wall inserts, wall inserts with plug-in sockets
and double wall inserts correspond in the delivered
state to the wall thickness stated on the order.
• The formwork spacing must be no smaller than
the wall thickness "X" specified for the wall insert
when the order was placed. The dimensions must
be checked before installation.
Nail the wall insert (in example HSI 150-K2) to the wooden
1
formwork using the nail holes (in the assembly frames or on
the pipe cover for the insert sleeve for HSI 150-GSM 160/X)
provided for this purpose. If the formwork is made of steel,
then attach the wall insert to the reinforcement with wire.
Next, close the formwork.
During the process of setting in concrete, make sure
2
compacting is carried out in layers in the vicinity of the
wall insert and around the HSI Packagings. Cavities must
be avoided.
Remove the formwork once the concrete has set.
15
EN
Formwork spacing
no smaller than
wall thickness "X"