Accessories - Milwaukee REDLITHIUM Manuel De L'utilisateur

9. The maximum vertical deviation (d) is:
dmax = 2X H (door opening) x ±1/8" ÷ 33'
Example: for a door opening height of 7', the
maximum permitted deviation (d) is:
dmax = 2 x 7' x ±1/8" ÷ 33' = ±0.05"
Therefore, the measurement between points III
and IV on the upper door opening should not
exceed 0.05" in a 7' doorway.
Plumb Dot Accuracy (3522-20)
A free measuring distance of approximately 33' be-
tween floor and ceiling on a firm surface is required
for this check. It is suggested to install riser block, if
not already equipped.
1. Place the tool within 1' of the floor.
Turn the tool to
Level & Plumb Lines Mode.
2. Set tool on ground and mark the center of the
plumb point on the ceiling (point I). Also, mark the
center of the plumb point on the floor (point II).
3. Rotate the tool 180°. Align the center point of the
laser beam directly onto the floor point II.
4. Mark the center of the top plumb point on the
reference line on the ceiling (point III).
5. The distance between points I and III on the ceiling
is the deviation (d) of the tool. This distance should
not exceed 1/8" (max.) at 33'.
For the Measuring distance of 2 x 16.5' = 33',
the maximum allowable deviation (d) is:
33' x ±1/8" ÷ 33' = ±1/8".
ON and to Perpendicular
16.5'
d
MAINTENANCE
To reduce the risk of injury, always
WARNING
remove the battery before perform-
ing any maintenance. Never disassemble the tool.
Maintain Laser Level
Maintain tools. If damaged, have the tool repaired
before use. Accidents may be caused by poorly
maintained tools.
To reduce the risk of personal in-
WARNING
jury and damage, never immerse
your tool in liquid or allow a liquid to flow inside
them.
Keep tool handles clean, dry and free of oil or grease.
Use only mild soap and a damp cloth to clean the
tool since certain cleaning agents and solvents are
harmful to plastics and other insulated parts. Some
of these include gasoline, turpentine, lacquer thin-
ner, paint thinner, chlorinated cleaning solvents,
ammonia and household detergents containing am-
monia. Never use flammable or combustible solvents
around tools.
Cleaning the Lenses
Blow off loose particles with clean compressed air.
Carefully wipe the surface with a cotton swab moist-
ened with water.
This tool has limited serviceable parts. Do not open
housing or disassemble tool. For repairs, return the
tool, battery pack and charger to the nearest autho-
rized service center.

ACCESSORIES

Use tools only with specifically
WARNING
designated accessories. Use of any
other accessories may create risk of injury.
SERVICE - UNITED STATES
1-800-SAWDUST
Monday-Friday, 7:00 AM - 6:30 PM CST
www.milwaukeetool.com
or visit
Contact Corporate After Sales Service Technical
Support with technical, service/repair, or warranty
questions.
Email: metproductsupport@milwaukeetool.com
B e c o m e a H e a v y D u t y C l u b M e m b e r a t
www.milwaukeetool.com to receive important
notifications regarding your tool purchases.
SERVICE - CANADA
Milwaukee Tool (Canada) Ltd
1.800.268.4015
Monday-Friday, 7:00 AM - 4:30 PM CST
or visit www.milwaukeetool.ca
8
Cleaning
Repairs
(1.800.729.3878)