Acoustic Signals - AEG FAVORIT 55602 W0P Notice D'utilisation

32 www.aeg.com
• The indicators
and
• The indicator
flash.
• The display shows the current
setting: e.g.
– The levels of rinse aid are
– Level 0 = no rinse aid is
3. Press Delay again and again to
change the setting.
4. Press the on/off button to confirm
the setting.
6.4 Use of rinse aid and multi-
tablets
The factory setting of the rinse aid
dispenser is with the dispenser activated.
This means that the rinse aid dispenser
always releases rinse aid.
It is possible to deactivate the rinse aid
dispenser, in this case the dispenser will
not release rinse aid only if the option
Multitab is activated.
If the dispenser is deactivated and you
do not select the option Multitab, the
dispenser will release rinse aid.
The use of the option Multitab with the
rinse aid dispenser deactivated may not
give satisfying drying results.
When the rinse aid dispenser is
deactivated, the rinse aid indicator is
always off when the option Multitab is
activated.
How to deactivate the rinse
aid dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators
flash and the display is blank.
2. Press Option.
,
go off.
continues to
= level 4.
from 0A to 6A.
released.
,
, and start to
• The indicators
go off.
• The indicator
continues to flash.
• The display shows the current
setting: = the rinse aid
dispenser is activated (factory
setting).
3. Press Option to change the setting.
= the rinse aid dispenser is
deactivated.
4. Press the on/off button to confirm
the setting.

6.5 Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators
,
flash and the display is blank.
2. Press Start
• The indicators
and go off.
• The indicator
• The display shows the current
setting:
3. Press Start to change the setting.
= Acoustic signal on.
4. Press the on/off button to confirm
the setting.
, and
,
and start to
,
continues to flash.
= Acoustic signal off.