Consumption Values; Information For Test Institutes; Settings - AEG FAVORIT 55602 W0P Notice D'utilisation

30 www.aeg.com

5.1 Consumption values

Programme
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the
quantity of dishes can change the values.
5.2 Information for test
institutes
For all the necessary information for test
performance, send an email to:

6. SETTINGS

6.1 Programme selection
mode and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The level of the water softener
according to the water hardness.
• The activation or the deactivation of
the acoustic signal for end of
programme.
• The deactivation of the rinse aid
dispenser when you want to use the
Multitab option without rinse aid.
• The level of rinse aid according to the
required dosage.
These settings will be saved until you
change them again.
Water
1)
(l)
10.2
7 - 14
12.5 - 14.5
12 - 14
10
4
Energy
(kWh)
0.932
0.6 - 1.4
1.4 - 1.6
0.7 - 0.9
0.9
0.1
info.test@dishwasher-production.com
Write down the product number (PNC)
that is on the rating plate.
How to set the programme
selection mode
The appliance is in programme selection
mode when the programme indicator
is on and the display shows the
programme duration.
When you activate the appliance, usually
it is in programme selection mode.
However, if this does not happen, you
can set the programme selection mode
in the following way:
Press and hold simultaneously Program
and Option until the appliance is in
programme selection mode.
6.2 The water softener
The water softener removes minerals
from the water supply, which would have
a detrimental effect on the washing
results and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
Duration
(min)
225
40 - 150
154 - 164
75 - 85
30
14