Repairs; Environmental Protection; Technical Specifications - Metabo STE 90 SCS Mode D'emploi

17026922_1010 STE 90 SCS STE 100 SCS NAFTA.book Seite 10 Mittwoch, 27. Oktober 2010 3:41 15
ENGLISH
ENG
K Lubricating stick for lubricating the saw blades
when sawing metal.
L Extraction hose
M Circular-cutting and parallel guide
For the complete range of accessories, see
www.metabo.com or refer to the main catalogue.
10.1 Attaching the circular-cutting and
parallel guide
For sawing circles (dia. 100 - 360 mm) and making
cuts parallel with edges (max. 210 mm).
Attaching clamping elements (page 4, Fig. I)
Place the clamping elements (a) on the footplate
(9) with the opening facing forwards and the
threaded hole facing up. Insert the screws (b) from
underneath.
Remove the clamping elements after use
otherwise the saw blade clamping fixture (2)
may be damaged when diagonal cuts are made.
Attaching the circular-cutting guide
(page 4, Fig. II)
- Slide the rod on the circular-cutting and parallel
guide sideways into the clamping elements (a)
(centre point (c) faces downwards).
- Set the desired radius (d).
- Tighten the screws (b).
Attaching the parallel guide (page 4, Fig. III)
- Slide the rod on the circular-cutting and parallel
guide sideways into the clamping elements (a)
(centre point (c) faces upwards).
- Unscrew the centre point (c).
- Set the dimension (e)
- Tighten the screws (b).

11 Repairs

Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
device.

12 Environmental Protection

Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
10

13 Technical Specifications

Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
M = Torque
T = Maximum material thickness in wood
1
T = Maximum material thickness in non-
2
ferrous metals
T = Maximum material thickness in sheet
3
steel
n = Stroke rate at idle speed
0
P = Nominal power input
1
P = Power output
2
m = Weight without mains cable
Wear ear protectors!
Machine in protection class II
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).