Bevel Cuts With The Circle-Cutting And Rip Guide; Repairs; Environmental Protection - Metabo STE 100 Plus Mode D'emploi

02_STE100_7230_0208_ENG
ENGLISH
Set dimension (b).
Tighten the screws (18) at the front.
After using the circle-cutting and rip guide, remove
the screws (18), as they are liable to work loose
with the vibration in the jig saw.
11.2 Bevel cuts with the circle-cutting and
rip guide
Remove the guard cover (8), the anti-splintering
foot-plate insert (9) and the chip-extraction
nozzle (12).
Slacken off the hexagon socket-head screw (15)
in the foot-plate (11). Slide the foot-plate (11)
forward, twist round and push backwards,
engaging in one of the notches for 15° and 30°
bevel angles.
To obtain a 45° bevel angle, swivel the
jig saw to the left. The jig saw must not
be swivelled to the right, as otherwise
the saw-blade clamping device may be
damaged.
Retighten the hexagon socket-head screw (15).

12 Repairs

Repairs to power tools must be carried
out by a qualified electrician only.
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please accompany the tool for repair with a brief
description of the fault identified.
16
19.02.2008 15:58 Uhr
Metabo packaging is 100% recyclable.
Power tools and accessories at the end of their
service life also contain large amounts of valuable
raw materials and plastics which can be fed back
into a recycling process.
These Operating Instructions are printed on paper
produced in a chlorine-free bleaching process.
electric equipment and its implementation in
national legal systems, used power tools must be
collected separately and handed in for
environmentally compatible recycling.
Seite 16

13 Environmental Protection

Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline
2002/96/EC on used electronic and